Table of Contents
Advertisement
NOTE: When host jobs have page sizes that do not match the Paper Size parameter, the printer will
behave based on the Paper Size Fault, Clip Page, and Move to TOF parameters.
Paper Size Fault
If a page is sent to the printer with dimensions that do not match the printer, then the following will happen
based on the Paper Size Fault menu selected.
•
Ignore (factory default). The page will print and the paper size length will be ignored. However, the
width will be clipped according to the front panel width setting.
•
Fault. The printer enters a fault state and goes offline. The user will need to either clear the fault and
continue, or load new media and change the Paper Size menu selection. Once the printer is back
online, printing will resume.
Clip Page
This menu defines the action when a page is sent to the printer with a length that is longer than the
selected paper size length.
•
Enable (factory default). The page will be clipped at the paper size length. In cases where the sent
page is longer than the paper size length, the "Move to TOF" menu setting has no effect since the
page is clipped at the TOF position.
•
Disable. The page will not be clipped and printing continues on the next page. The action taken by
the printer when printing of the page completes is determined by the Move to TOF menu.
NOTE: Page clipping at paper size width is always enabled to protect against printing on the platen.
Move to TOF
When the page length given does not match the printer, the printer driver will have to determine how the
TOF is kept relative to each page printed. The following menu options are available through the front
panel and the driver:
•
Disable. Only when the FF key is pressed.
•
At End of Job. After the Current Job.
•
At End of Page (factory default). After each Page Printed.
Gray Adjust
This menu adjusts the darkness of the gray elements on the page by gradually reducing or increasing the
amount of dots that are placed in the halftone patterns. Pure white and black colors are not affected by
setting.
The menu ranges from -10 to +10. The default value is 0.
-1
0
8
9
185
Advertisement
Table of Contents
