Table of Contents
Advertisement
28. Turn the platen stop knob clockwise or counterclockwise to match the paper thickness. (The 1-3-6
scale corresponds approximately to 1-, 3-, and 6-part paper thickness. Adjust until you have the
desired print quality).
NOTE: The platen stop allows you to set an optimum and consistent thickness that is not affected when
opening and closing the platen lever.
29. Lower the platen lever until it stops.
30. Press ONLINE to clear any fault messages (such as "LOAD PAPER") from the LCD.
31. Press TOF. The top-of-form you have set moves down to the print position. If there is data in the
buffer, the paper moves forward to the last print position on the next page.
32. Press ONLINE and close the printer cover.
Unload Paper
1. Press ONLINE to place the printer in offline mode and open the printer cover.
2. For cabinet models, open the cabinet rear door.
3. Tear off the paper at the perforation.
4. Allow the paper to fall to the back of the printer and into the paper stacking area.
5. For pedestal models, remove the stacked paper from the paper tray.
6. For cabinet models, remove the stacked paper from the rear cabinet floor.
7. Close the cabinet rear door.
Figure 15 Unloading the Paper from the Printer
Paper
Perforation
35
Advertisement
Table of Contents
