Problems Related To Transmission - Sharp MX-4100N Operation Manual

PROBLEMS RELATED TO TRANSMISSION

Problem
Transmission does
not take place.
Point to check
Is the telephone line connected
securely?
Is the correct dial mode set for your
line?
Is a busy signal received?
Did a communication error occur?
Does a message appear indicating that
the memory is full?
Does a message appear notifying you
that the original size was not detected?
Check the telephone line jack, the wall jack, and any
extension adapters to make sure that all connections
are secure.
☞
SIDE AND BACK
Ask your administrator to verify that "Dial Mode Setting"
is set correctly for the line you are using.
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Default Settings" >
"Dial Mode Setting"
If a busy signal is received, the transmission is
temporarily canceled and then automatically
re-attempted after a brief interval. (Factory default
setting: 2 attempts, 3 min. intervals)
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Send Settings" >
"Recall in Case of Line Busy"
To cancel the transmission, press the [JOB STATUS]
key, touch the key of the job that you wish to cancel,
and then touch the [Stop/Delete] key.
If an error occurs that prevents transmission, the
transmission is temporarily canceled and then
automatically re-attempted after a brief interval.
(Factory default setting: 3 min. intervals)
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Send Settings" >
"Recall in Case of Communication Error"
To cancel the transmission, press the [JOB STATUS]
key, touch the key of the job that you wish to cancel,
and then touch the [Stop/Delete] key.
The machine supports error correction mode (ECM) and
is configured to automatically resend any part of a fax
that is distorted due to noise on the line.
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Default Settings" >
"ECM"
If the memory becomes full, the transmission will be
canceled. Divide the originals into sets and fax each set
separately, or use direct transmission.
Place the original again. If the original size is still not
detected correctly, specify the original size manually.
8-26
TROUBLESHOOTING
Solution
(page 1-7)
Contents