Sharp MX-4100N Operation Manual page 178

Changing the copy settings for each set of originals
The copy settings (Exposure, Paper Select, and Copy Ratio only) can be changed for each set of originals.
Perform the step below before pressing the [Start] key to scan the originals in step 4 above.
Place next original and press [Start].
to change copy settings,
press [Change].
1
Color Mode
Full Color
Exposure
2
Auto
Copy Ratio
Original
100%
• The color mode cannot be changed with the [Color Mode] key.
• The original size cannot be changed manually with the [Original] key. If the automatic original detection function is
operating, the original size will be detected for each set of originals placed.
• When the bypass tray is selected, it is not possible to change the paper type.
• If "XY Zoom" was set for the ratio when the previous original was scanned, it will not be possible to change the ratio.
• When "Job Build" is used in combination with the functions below, the [Change] key will not appear in the screen of step 1
above.
Pamphlet copy, tandem copy, covers/inserts, transparency inserts, multi-shot, book copy, tab copy, staple sort, saddle
stitch
Change Read-End
Read-End
Plain
8½x11
1. 8½x11
8½x11R
2.
8½x14
3.
4. 11x17
Paper Select
Auto Auto
8½x11
8½x11
Plain
Touch the [Change] key.
Change the desired copy settings in the
screen that appears and press the [Start]
key.
Scanning of the originals will begin using the changed copy
settings.
To cancel the copy setting changes and begin copying without
scanning the new originals, touch the [Read-End] key.
2-57
COPIER
Contents