PROBLEMS RELATED TO TRANSMISSION
Problem
Transmission does
not take place.
Point to check
Is the telephone line connected
securely?
Is the correct dial mode set for your
line?
Is a busy signal received?
Did a communication error occur?
Does a message appear indicating that
the memory is full?
Check the telephone line jack, the wall jack, and any
extension adapters to make sure that all
connections are secure.
☞
SIDE AND BACK
Ask your administrator to verify that "Dial Mode
Setting" is set correctly for the line you are using.
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Default Settings" >
"Dial Mode Setting"
If a busy signal is received, the transmission is
temporarily canceled and then automatically
re-attempted after a brief interval. (Factory default
setting: 2 attempts, 3 min. intervals)
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Send Settings" >
"Recall in Case of Line Busy"
To cancel the transmission, press the [JOB STATUS]
key (
), touch the key of the job that you wish to
cancel, and then touch the [Stop/Delete] key.
If an error occurs that prevents transmission, the
transmission is temporarily canceled and then
automatically re-attempted after a brief interval.
(Factory default setting: 3 min. intervals)
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Send Settings" >
"Recall in Case of Communication Error"
To cancel the transmission, touch the [JOB STATUS]
key (
), touch the key of the job that you wish to
cancel, and then touch the [Stop/Delete] key.
The machine supports error correction mode (ECM) and
is configured to automatically resend any part of a fax
that is distorted due to noise on the line.
➞ System Settings (Administrator) > "Image Send
Settings" > "Fax Settings" > "Fax Default Settings" >
"ECM"
Divide the originals into sets and fax each set
separately, or use direct transmission.
If the memory becomes full, the transmission will be
canceled.
8-20
TROUBLESHOOTING
Solution
(page 1-6)
Contents