Table of Contents
Advertisement
Figure 61. Removing the front mounting front PERC module
Next steps
Replace the front mounting front PERC
module.
Installing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
Safety
instructions.
2. Follow the procedure listed in
Before working inside your
system.
3. If installed,
remove the air
shroud.
4. Route the cable properly to prevent the cable from being pinched or crimped.
Steps
1. Connect the PERC cable to the front PERC module.
2. Align the front PERC module at an angle until the tray touches the slot in the system.
3. Press the front PERC module connector with the connector on the drive backplane until firmly seated.
4. Using a Phillips #2 screwdriver, tighten the thumbscrews on the front PERC module.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Installing and removing system components
67
Advertisement
Table of Contents
