Table of Contents
Advertisement
Figure 45. Removing the rear mounting front PERC module
Next steps
1.
Replace the rear mounting front PERC
Installing the rear mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the drive backplane
4. Disconnect all the cables from rear mounting front PERC module, observe the cable routing.
Steps
1. Align the connectors and guide slots on the rear mounting front PERC module with the connectors and guide pins on the
drive backplane.
2. Slide in the rear mounting front PERC module, until the module is connected to the drive backplane.
3. Using a Phillips #2 screwdriver, tighten the captive screws on the rear mounting front PERC module.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
module.
Safety
instructions.
Before working inside your
cover.
system.
Installing and removing system components
83
Advertisement
Table of Contents
