Ipv6 Static Route - ZyXEL Communications XS1930-12HP User Manual

Table 130 IP Application > Static Routing > IPv4 Static Route (continued)
LABEL
Gateway IP
Address
Metric
Add
Cancel
Clear
Index
Active
Name
Destination
Address
Subnet Mask
Gateway
Address
Metric
Delete
Cancel

32.4 IPv6 Static Route

Click the link next to IPv6 Static Route in the IP Application > Static Routing screen to display the screen
as shown.
Chapter 32 Static Route
DESCRIPTION
Enter the IP address of the gateway. The gateway is an immediate neighbor of your Switch that
will forward the packet to the destination. The gateway must be a router on the same segment
as your Switch.
The metric represents the "cost" of transmission for routing purposes. IP routing uses hop count as
the measurement of cost, with a minimum of 1 for directly connected networks. Enter a number
that approximates the cost for this link. The number need not be precise, but it must be between
1 and 15. In practice, 2 or 3 is usually a good number.
Click Add to insert a new static route to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel to save
your changes to the non-volatile memory when you are done configuring.
Click Cancel to reset the above fields to your previous configuration.
Click Clear to set the above fields back to the factory defaults.
This field displays the index number of the route. Click a number to edit the static route entry.
This field displays Yes when the static route is activated and NO when it is deactivated.
This field displays the descriptive name for this route. This is for identification purposes only.
This field displays the IP network address of the final destination.
This field displays the subnet mask for this destination.
This field displays the IP address of the gateway. The gateway is an immediate neighbor of your
Switch that will forward the packet to the destination.
This field displays the cost of transmission for routing purposes.
Select an entry's check box to select a specific entry. Otherwise, select the check box in the
table heading row to select all entries.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the check boxes.
XS1930 Series User's Guide
260