Mac Based Vlan - ZyXEL Communications 43222612 User Manual

The following table describes the fields in the above screen.
Table 56 Advanced Application > VLAN > VLAN Configuration > Voice VLAN Setup
LABEL
Voice VLAN Global Setup
Voice VLAN
Priority
Apply
Cancel
Clear
Voice VLAN OUI Setup
OUI address
OUI mask
Description
Add
Cancel
Index
OUI address
OUI mask
Description
Delete
Cancel

9.10 MAC Based VLAN

The MAC-based VLAN feature assigns incoming untagged packets to a VLAN and classifies the traffic
based on the source MAC address of the packet. When untagged packets arrive at the Switch, the
source MAC address of the packet is looked up in a MAC to VLAN mapping table. If an entry is found,
the corresponding VLAN ID is assigned to the packet. The assigned VLAN ID is verified against the VLAN
table. If the VLAN is valid, ingress processing on the packet continues; otherwise, the packet is dropped.
Chapter 9 VLAN
DESCRIPTION
Click the second radio button if you want to enable the Voice VLAN feature. Enter a
VLAN ID number that is associated with the Voice VLAN.
Click the Disable radio button if you do not want to enable the Voice VLAN feature.
Select the priority level of the voice traffic from 0 to 7. Default setting is 5. The higher the
numeric value you assign, the higher the priority for this voice traffic.
Click Apply to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this section afresh.
Click Clear to reset the fields to default settings.
Enter the IP phone manufacturer's OUI MAC address. The first 3 byes is the manufacturer
identifier, the last 3 bytes is a unique station ID.
Enter the mask for the specified IP phone manufacturer's OUI MAC address to determine
which bits a packet's MAC address should match.
Enter "f" for each bit of the specified MAC address that the traffic's MAC address should
match. Enter "0" for the bits of the matched traffic's MAC address, which can be of any
hexadecimal characters. For example, if you set the MAC address to 00:13:49:00:00:00
and the mask to ff:ff:ff:00:00:00, a packet with a MAC address of 00:13:49:12:34:56
matches this criteria.
Enter a description up to 32 characters for the Voice VLAN device. For example: Siemens.
Click Add to save your changes to the Switch's run-time memory. The Switch loses these
changes if it is turned off or loses power, so use the Save link on the top navigation panel
to save your changes to the non-volatile memory when you are done configuring.
Click Cancel to begin configuring this section afresh.
This field displays the index number of the Voice VLAN.
This field displays the OUI address of the Voice VLAN.
This field displays the OUI mask address of the Voice VLAN.
This field displays the description of the Voice VLAN with OUI address.
Select an entry's check box to select a specific entry. Otherwise, select the check box in
the table heading row to select all entries.
Click Delete to remove the selected entry from the summary table.
Click Cancel to clear the check boxes.
GS2220 Series User's Guide
148