Adding A Line-Based Voice-Mail Server - Nortel 5100 User Manual

140
In addition, an SMDI TELNET session is configured to allow the Session
Manager to directly communicate call setup information to the voice-mail server.
The SMDI link is also used by the Session Manager to receive SMDI MWI
messages.

Adding a line-based voice-mail server

To add a line-based voice-mail server
1
2
Parameter Type
Name String (200)
Type Select from
drop down
list
Client contact String (400)
App.Svr.Address String
(Long name
of the
Session
Manager)
NN42020-105 MCS 5100 Release 4.0 Standard 01.06 November 2007
Select Voice Mail > Add Line VMS.
The Add a new Line Voicemail Server window appears.
Enter parameter information and values about the line-based voice-mail
server as described in the following table.
Range
Up to 200
characters
PRI_TRUNK
CAS_TRUNK
Up to 400
characters
(Long name of
the Session
Manager)
Default Description
None The name that identifies the
line-based voice-mail server.
PRI_TRUNK A specification of the voice mail
Gateway Lines.
Voice mail The field used to route voice mail.
In most cases, you use the default
(voice mail). If you require a
different client contact, contact
your technical support
representative.
ServerHome. With Specifies that the Session
this default, each Manager that hosts the voice-mail
Session Manager server being provisioned. This
ignores this field parameter is used in an N+1
and forward SIP environment. All Session
requests to the Managers (that are not the home
voice-mail server Session Manager) forward
instead of requests destined to voice mail to
forwarding them to the address specified in this field.
a home Application
Note: From the drop-down list,
Server.
you must select a Session
Manager configured on the
system.