Ricoh Aficio MP C3001 Service Manual page 1835

Code Meaning
G3 ECM - error frames still
received at the other end
6-10
after all communication
attempts at 2400 bps
V.21 flag detected during
6-21 high speed modem
communication
The machine resets the
sequence because of an
6-22
abnormal handshake in the
V.34 control channel
V.21 signal not stopped
6-99
within 6 s
SIP user name registration
13-17
error
13-18 SIP server access error
13-24 SIP authentication error
13-25 Network I/F setting error
Network I/F setting error at
13-26
power on
13-27 IP address setting error
SM
Suggested Cause/Action
Check for line noise.
Adjust the tx level (use NCU parameter 01 or
the dedicated tx parameter for that address).
Check the line connection.
Defective remote terminal.
The other terminal may be defective or
incompatible.
Check for line noise.
If the same error occurs frequently, replace the
FCU.
Defective remote terminal.
Replace the FCU.
Double registration of the SIP user name.
Capacity for user-name registration in the SIP
server is not sufficient.
Incorrect initial setting for the SIP server.
Defective SIP server.
Registered password in the device does not
match the password in the SIP server.
IPV4 is not active in the active protocol setting.
IP address of the device is not registered.
Active protocol setting does not match the I/F
setting for SIP server.
IP address of the device is not registered.
IP address of the device is not registered.
31
Error Codes
D545