Ricoh Aficio MP C3001 Service Manual page 1831

Code Meaning
The line was disconnected
0-80 due to a timeout in V.34
phase 2 – line probing.
The line was disconnected
due to a timeout in V.34
0-81
phase 3 – equalizer
training.
The line was disconnected
due to a timeout in the V.34
0-82
phase 4 – control channel
start-up.
The line was disconnected
due to a timeout in the V.34
0-83
control channel restart
sequence.
The line was disconnected
due to abnormal signaling
0-84
in V.34 phase 4 – control
channel start-up.
The line was disconnected
due to abnormal signaling
0-85
in V.34 control channel
restart.
The line was disconnected
because the other terminal
requested a data rate
0-86
using MPh that was not
available in the currently
selected symbol rate.
SM
Suggested Cause/Action
The guard timer expired while starting these
phases. Serious noise, narrow bandwidth, or
low signal level can cause these errors.
If these errors happen at the transmitting terminal:
Try making a call at a later time.
Try using V.17 or a slower modem using
dedicated tx parameters.
Try increasing the tx level.
Try adjusting the tx cable equalizer setting.
If these errors happen at the receiving terminal:
Try adjusting the rx cable equalizer setting.
Try increasing the tx level.
Try using V.17 or a slower modem if the same
error is frequent when receiving from multiple
senders.
The signal did not stop within 10 s.
Turn off the machine, then turn it back on.
If the same error is frequent, replace the FCU.
The signal did not stop within 10 s.
Turn off the machine, then turn it back on.
If the same error is frequent, replace the FCU.
The other terminal was incompatible.
Ask the other party to contact the
manufacturer.
27
Error Codes
D545