Ricoh Aficio MP C3001 Service Manual page 1913

Communication Switch 14 (SP No. 1-104-021)
No Function
Inch-to-mm conversion during
0 transmission
0: Disabled, 1: Enabled
1-5 Not used
Available unit of resolution in which fax
messages are received
Bit 7 Bit 6
0 0
6-7
0 1
1 0
1 1
SM
0: In immediate transmission, data
scanned in inch format are transmitted
without conversion.
In memory transmission, data stored in
the SAF memory in mm format are
transmitted without conversion.
Note: When storing the scanned data
into SAF memory, the fax unit always
converts the data into mm format.
1: The machine converts the scanned
data or stored data in the SAF memory
to the format which was specified in the
set-up protocol (DIS/NSF) before
transmission.
Do not change the factory settings.
For the best performance, do not change
Unit
the factory settings.
The setting determined by these bits is
mm
informed to the transmitting terminal in
inch
the pre-message protocol exchange (in
the DIS/NSF frames).
mm and inch
Not used
109
Bit Switches
Comments
D545