Ricoh Aficio MP C3001 Service Manual page 1881

No Function
TTI printing position
0: Superimposed on the page
0 data
1: Printed before the data
leading edge
TSI (G3) printing position
0: Superimposed on the page
1 data
1: Printed before the data
leading edge
2 Not used
TTI used for broadcasting
0: The TTIs selected for each
3 Quick/Speed dial are used
1: The same TTI is used for all
destinations
4-7 Not used
No Function
TTI printing position in the main
0-7
scan direction
SM
System Switch 11 (SP No. 1-101-018)
Change this bit to 1 if the TTI overprints
information that the customer considers to be
important (G3 transmissions).
NOTE: If "1" is selected, it is possible that sent
data is printed on two sheets of paper.
Change this bit to 1 if the TSI (G3) overprints
information that the customer considers to be
important.
Do not change the factory settings.
1: The TTI (TTI_1 or TTI_2) which is selected
for all destinations during broadcasting.
Do not change the factory settings.
System Switch 12 (SP No. 1-101-019)
TTI: 08 to 92 (BCD) mm
Input even numbers only.
This setting determines the print start position
for the TTI from the left edge of the paper. If the
TTI is moved too far to the right, it may
overwrite the file number which is on the top
right of the page. On an A4 page, if the TTI is
moved over by more than 50 mm, it may
overwrite the page number.
77
Bit Switches
Comments
Comments
D545