The manual of 4HP14 A/T removing and installing
CHERY AUTOMOBILE CO., LTD
NOTE:
The washer thickness should be adjusted as
procedures in section 1.4.1 in page 5/1. The
adjusting washer is installed between the cam
and the housing. Therefore brake rotor must be
removed, and pull shift shaft out enough as
necessary.
Install shift shaft elastic pin 06 090 with special
tool 5×46 000 119 and a hammer.
NOTE: The elastic pin opening side must face to
transmission input or output direction.
Insert pawl dowel pin 24 060 half into the house,
and place retracting spring 24 050 on dowel pin.
-70-