Chery A11 2003 Repair Manual page 213

Fig. 129 distributor assembly
tongue
camshaft
groove
Fig. 130
Slave cylinder and high pressure
wiring harness carrier
PDF 文件使用 "pdfFactory Pro" 试用版本创建
——Loosen and remove two M6× 20 bolts.
——Remove the distributor.
——remove the distributor's "O "seal.
Assembly:
——Insure that the engine is set correctly with No.1 Cylinder
at TDC.
TDC mark
——install new "O" seal.
——Rotate distributor to align the lug with the No. 1 cylinder
TDC mark on the distributor flange. install the distributor
inserting the lug into the camshaft groove.
——Rotate distributor to align the mark on distributor flange
with the mark on cylinder head.
——Tighten two bolts to 5.0—7.0Nm.
6. High tension ignition wire assembly:
The high tension ignition wire assembly is mounted on the
cylinder wire bracket which is installed on the valve cover ,
also cylinder wire and coil wire clips exist between the
distributor and cylinder wires bracket.
Slave cylinder and
high pressure wiring
harness
Fig. 131
www.fineprint.com.cn
CAC Gasoline Engine Maintenance And Servicing Manual
Slave cylinder and high pressure wiring harness
High pressure
assembly
bolt
Flat washer
69