Chery A11 2003 Repair Manual page 170

2.Cylinder cover bolts removal and cylinder head assembly installation
Fig.20
Fig.21
A dowel B cylinder head
Fig.23
PDF 文件使用 "pdfFactory Pro" 试用版本创建
Cylinder head bolts removal：
——Rotate camshaft until keyway is rightly upside.
——Loosen cylinder cover bolts in order as specified in
diagram.
——Note：Cylinder cover bolts must be replaced after
removed and are not permitted to reuse.
Cylinder head assembly reinstallation：
Fig.22
gasket
CAC Gasoline Engine Maintenance And Servicing Manual
——Check whether cylinder head contact surface
roughness is 0.15mm or less.
——Clean the tapped holes in cylinder block，there should
not be deposits in tapped hole，or fluid pressure resulting
from bolts screwing may possibly results in cylinder block
cracking.
——Rotate crankshaft until no.1 cylinder piston is 20mm
or so under the deck of cylinder block to keep the valves in
cylinder head assembly from contacting piston head.
——Match cylinder head gasket with dowels.
Note： For cylinder head gasket mark, 2 tooth indicates 478，
1 teeth indicates 480 ,and position cylinder head gasket
with part number side upside.
——Install cylinder head into place with camshaft keyway
perpendicularly downward.
Note： Cylinder head gasket may only be used once ， gasket
should be replaced if cylinder head is removed.
www.fineprint.com.cn
26