Chery A11 2003 Repair Manual page 141

Fig. 73
A. crankshaft to oil pump shell
B. crankshaft to rear oil seal carrier
fig. 74
Fig.75
Usage, repair and maintenance specification of CAC gasoline engine
2) The removal and installation of oil pan：
removal：
——Loosen drain plug and drain oil
——Loosen eighteen M6×20 bolts
——Take out the sealing gasket of oil pan
——Check if the left and right reinforced plates are still
clipped on the back face of oil pan flange face
Installation：
— — Apply locite 598 sealant and G Y409 anaerobic
sealant on the joint place between flange surface of oil pan
of cylinder body and oil pump case, and carrier of real oil
seal.
——Put the new rubber seal gasket on the cylinder body
and have the two sides of sealing gasket enter into the
grooves of carrier of real oil seal and oil pump.
——Install the oil pan with the two sides of sealing gasket
in the grooves of oil pan.
——Screw the bolt by hand (the bolt with washer indicated
in the left upper figure is precedent.)
— — Tighten bolts to 5.0 — 8.0Nm according to the
sequence of the left figure.
——Replace the sealing gasket of drain plug. Screw in the
forward
drain plug by hand and tighten to 21—25Nm.
43