Connecting The Jsa5800 Appliance To A Management Device - Juniper JSA5800 Hardware Manual

Connecting the JSA5800 Appliance to a
Management Device
You can control the JSA5800 appliance through a connected management device (such as a laptop). Use
the console port to connect your laptop as shown in
Figure 14: Connecting the Management Device
JSA5800 Back Panel Components table for the location of the ports in
Refer to the
Back Panel Description" on page
NOTE: You can choose any GB ports as the management port.
To connect a management device with the JSA5800 appliance:
1. Connect external devices using the ports on the back panel of the appliance.
2. If you use a laptop, connect the laptop to the DB-9 serial console port on the back panel.
3. Plug an Ethernet cable into the network port on the back panel.
Figure 14 on page
9.
35.
"JSA5800 Appliance
35