Connecting A Junos Space Appliance To A Management Console; Figure 13: Ja2500 Appliance Front Panel - Juniper JA2500 Hardware Manual

Juniper Networks JA2500 Junos Space Appliance Hardware Guide
Related
Documentation

Connecting a Junos Space Appliance to a Management Console

88
For more information about Junos Space Ethernet interfaces, see
Interfaces Overview" on page
To connect the appliance to the network, do the following:
(Optional) Attach an electrostatic discharge (ESD) grounding strap to your bare wrist
1.
and connect the strap to an external ESD point.
Plug one end of the Ethernet cable into the port labeled
2.
Figure 13 on page 88, on the front panel.

Figure 13: JA2500 Appliance Front Panel

(Optional) If you are using eth1 interface, take an Ethernet cable and plug one end of
3.
the Ethernet cable into the port labeled
contains the Junos Space nodes in the fabric.
Plug the other end of the Ethernet cable into the network.
4.
NOTE: If you choose to connect the JA2500 appliance to more than one
Ethernet interfaces, then you should plug the other end of the Ethernet
cable into the network that contains the Web UI clients and the other
Junos Space nodes in the fabric.
Connecting a Junos Space Appliance to a Management Console on page 88
Booting the Junos Space Appliance on page 91
You can configure and manage a Junos Space Appliance by using a dedicated console.
Every appliance has a console port with an RJ-45 connector. Use the console port to
connect the appliance to the management console or to a console server. Ensure that
you have an Ethernet cable with an RJ-45 connector available. An RJ-45 cable, as shown
in Figure 14 on page 89, and an RJ-45 to DB-9 serial port adapter are supplied with the
appliance.
4.
and the other end into the network that
1
Copyright © 2018, Juniper Networks, Inc.
"Junos Space Ethernet
, as shown in
0