Table of Contents
Advertisement
Preparation for Measurement
Measurement
Measurement
After doing all the preparations you can now proceed to measurement.
The Agilent E5022/E5023 has a pre-installed VEE measurement program. This
measurement program allows the user to do basic measurements. Detailed description on
how to use the measurement program is written in Chapter 3. This software controls the
system by calling the Agilent E5022/E5023 DLL measurement library from VEE.
The measurement process will not change whether the user executes his own program or
the provided measurement program.
Closing the System
Close the system before turning off the system. In the case of the VEE measurement
program, exit the program.
Switch off the System
After executing the measurement program, check if the spinstand stopped from rotating.
Switch off the power of each instrument in the following order.
1. Switch off the VXI mainframe and other measuring instruments.
2. Switch off the spinstand.
3. Switch off the PC and its monitor.
Turn off the air compressor and vacuum air AFTER switching off all power supply.
Shutting down the PC
To shut down your PC follow the procedures listed below.
1. To shutdown the PC, click on [Start] menu from the left side of the task bar and click
[Shutdown].
NOTE
If problem occurs during shutdown and the software hangs, then after one minute, push the
power switch of the PC for ten seconds. This turns off the power but may result in the lost
of data.
42
Chapter 2
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Advertisement
Table of Contents
