Table of Contents
Advertisement
Adjusting the FIC length
The length of the FIC can be adjusted if it is FIC type cassette. This length can be adjusted
in three different settings i.e., short, medium or long. This procedure shows the E5029C
option C11. Other cassettes have the same adjustment procedure.
Table C-5
1. Before measuring the Z-height of the cassette, you must set the length of the HGA
mount block assembly. This length can be adjusted into three different settings i.e.,
short, medium or long as shown in Figure C-12.
2. Remove the two screws as shown in Figure C-12 using a 1.5-mm hex screwdriver.
3. Slowly tighten up the screws after setting the desired length of the FIC block.
NOTE
The location of the needle pin of the Z-height tool (i.e. short, medium or long) should
match the length of the HGA Mount block assembly in which the customer decides to use.
Refer to Figure C-7.
Appendix C
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Required Tools
Tools
Hex Screwdriver
Cassette and Z-Height Adjustment
Adjusting the FIC length
Size
1.5 mm
401
Advertisement
Table of Contents
