Changes In Revision A.03.81 From Revision A.03.70 - Agilent Technologies E5035A Operation Manual

Changes in Revision A.03.81 from Revision A.03.70

For VEE program, the following measurements have been added.
• Stability Measurement (Absolute Time Setting), This test allows the user to set up the
write and read operation in each segment as a function of absolute time so that test
results can be closely correlated similar to popcorn noise test.
For VEE program, the following parameters have been added and/or modified:
• The following spindle speed limitations must be taken into account, when the user
specifies the 'RPM' parameter in the [Setup] menu. When RPM is set below 2400, the
system will automatically set the spindle speed to 2400[rpm]. When RPM is set above
2400, then the user's specified spindle speed will be used. Refer to the
"hpe5022_measureStability" and "hpe5022_measureAbsStability" functions of the
programming manual for details.
Appendix A
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Changes in Revision A.03.81 from Revision A.03.70
Spindle Speed Limitations
RPM = spindle speed, when spindle speed ≥ 2400 [rpm]
RPM = 2400 rpm, when the spindle speed is set below 2400
[rpm
Manual Changes
367