Partial Erasure Measurement - Agilent Technologies E5035A Operation Manual

VEE Measurement Program Operation
Measurement

Partial Erasure Measurement

Overview This section describes the Partial Erasure Measurement. This measurement is performed
by a parametric module.
Measurement
1. To open the Partial Erasure menu, click on the [Partial Erasure] button from the
Procedure
Figure 3-119 Partial Erasure Menu
NOTE
Before you execute this measurement, you should set an appropriate input range or execute
the Auto Configuration to set the input range automatically.
2. Set the parameters, click on each button to enter a new value.
NOTE The parameter values of Channel Bit Rate, Write Current and Sense Current that have been
set in the [Configuration] menu will automatically update similar parameters in this menu.
3. Click on the [Measure] button to start measurement.
196
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Measure menu.
Channel Bit Rate
Write Current
Sense Current
Track #
Average
Specifies the speed at which data bits are
written on the media per second [bps].
Specifies the current applied to the write head.
Specifies the current applied to the read head.
Specifies the track number to be tested.
Specifies the number of revolutions to get the
average results.
Chapter 3