Table of Contents
Advertisement
Exit the VEE measurement program
1. Click on the [Quit] button from the Measure menu. A pop-up window will appear that
will ask the user to store the current setting. If "yes" is selected the parameters set in the
Configuration menu will be saved. This newly saved parameters will be the default
parameters in the configuration menu the next time the user runs the program.
NOTE
To end the program make sure that you click the [Quit] button. If you click the VEE stop
button (i.e, the 'x' mark on the upper right corner of the menu) to end the program, it could
cause an initialization failure of the VEE program the next time you run the program.
Figure 3-133
Storing the current setting
Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
VEE Measurement Program Operation
Exit the VEE measurement program
215
Advertisement
Table of Contents
