Table of Contents
Advertisement
Baseline Popping Measurement
Overview
This section describes the Baseline Popping Measurement. This measurement allows you
to evaluate the Narrow Band TAA level.
Measurement
1. To open the Baseline Popping menu, click on the [Baseline Popping] button from the
Procedure
Parameter Sweep frame of the Measure menu.
Figure 3-94
Baseline Popping Menu
NOTE
Before you execute this measurement, you should set an appropriate input range or execute
the Auto Configuration to set the input range automatically.
2. Set the parameters, click on each button to enter a new value.
Channel Bit Rate
Write Current
Data Pattern
Track #
Sense Curr. Start
Sense Curr. Stop
Chapter 3
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
VEE Measurement Program Operation
Specifies the speed at which data bits are
written on the media per second [bps].
Specifies the current applied to the write head.
Specifies the data pattern to be written on the
test track. To set the data pattern, click on the
[Configuration] > [Setup] > [Pattern Config]
buttons to open the data pattern menu.
Specifies the track number to be tested.
Specifies the starting point of the sense
current.
Specifies the stopping point of the sense
current.
Measurement
143
Advertisement
Table of Contents
