Table of Contents
Advertisement
Manual Changes
Changes at Revision A.03.10 from Revision A.03.00
Changes at Revision A.03.10 from Revision A.03.00
•
The parameter 'Average' is added in the following measurement menus.
•
BER Measurement
•
747 Measurement
•
Bath tub Measurement
•
Channel Quality Measurement
•
For Bit Error measurement, the 'Initialize for Optimization' parameter is added in the
Optimize Menu.
•
For Popcorn Noise Measurement, the read aperture time parameter has been added that
allows you to set the time to read the data. Also, the number of segments per track is set
automatically.
•
For Triple Track Measurement, the data pattern for adjacent track can be selected. Also
DC and AC data patterns can be selected as erase pattern.
•
For the spectrum analyzer, the display can be turned on which allows you to observe
the measurement waveform.
•
The function of the read/write offset is set automatically after the head movement.This
has been added in the setup menu. When this function is turned on, the track profile
measurement is done automatically after track number is changed, then read/write
offset is set. This function is valid only for the HP VEE demo program.
•
The serial number of the system and each module is made viewable in the "About
Agilent E5022A" menu.
376
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
Appendix A
Advertisement
Table of Contents
