Ricoh FT5034 Service Manual page 98

5.3 INPUT CHECK MODE
When you enter the SP mode 88, the copier displays the sensor readings on the
monitor.
NOTE: Before checking the sensor data with this input check mode, you have to
leave the SP mode.
MODE
Vsp
Vsg
BIAS Voltage
ID-SENSOR Input Voltage "=
ADS Data
ADS Input Voltage
DRUM Temperature
After checking the sensor data, enter SP mode 88 again and reset it to 10 (normal
operating mode).
1 2
"= " "1" "=
"= " "1" "=
"= " "1" "=
" "2" "=
"= " "3" "=
"= " "4" "=
"= " "5" "=
- 97 -
3 4
"
" "
While the "#" key is hold down.
" " "
While the "0" key is held down.
" " "
"
" "
"
" "
"
" "
"
(Start key)
REMARKS