Ricoh FT5034 Service Manual page 96

No.
Forced Start
87*
Input Check
88
Key Card Operation
90*
Max. Magnification Ratio
91
Bookcopy Operation
95
(NOTE 4)
Memory All clear
99*
(CAUTION: SEE NOTE 1)
NOTES:
1. Memory All Clear Mode (SP99) clears all the correction data for copy process
control and the software counters, and returns all the modes and adjustments to
the default settings. Normally, this SP mode should not be performed. This
procedure is required only when the copier malfunctions due to a damaged RAM
board or when the RAM board is replaced.
CAUTION: Memory all clear is done immediately after you press the "0" key to
change the setting from "10" to "11" .
2. A "*" after an SP mode number means that the mode can be accessed by service
representatives only: SP11, SP13, SP24, SP33, SP34, SP35, SP58, SP63,
SP83, SP84, SP85, SP86, SP87, SP90, SP91, SP99.
3. SP24, SP58, SP83, SP84, SP85, SP86, SP87
These modes are for testing only and do not operate when you exit SP mode.
4. SP95
You can use this mode when you want to copy a book. It gives a 6 ~ 7 second
interval between copy cycles when more than "1" is entered in the copy counter.
5. SP88
You can check the data from the sensors. You have to reset this mode after
checking the values on the monitor.
6. SP33
This SP mode is not applied in this model but the program includes this number.
Mode Defaults
(NOTE 3)
(NOTE 5)
10: Normal
10 11: The ready temperature is ignored to turn the
Start key green. (Factory use only)
10: Normal
10 11: Input data from the sensors is displayed.
Refer to section 5-3.
10: Not used
10
11: The Key Card operates.
10: 155%
11
11: 200%
10: OFF
10
11: Bookcopy operates.
10: No
10
11: Yes
- 95 -
Data