Ricoh FT5034 Service Manual page 61

3. Remove the development brush cover (2
screws).
4. Set the development unit on a large sheet
of paper with the unit's inlet facing
downward.
5. Turn the paddle roller knob
counterclockwise. The developer will fall
out onto the paper.
6. Hold the unit at an angle and dump out the
developer that has collected at the ends of
the development unit.
7. Repeat the above steps until you have
removed all of the developer.
NOTE: If developer remains in the
development unit, the rotating part
might break because of
development roller overload.
8. Pour one bag of developer into the
development unit while turning the knob
counterclockwise to distribute the
developer evenly.
- 60 -
Development
Brush Cover
Developer
Knob