Ricoh FT5034 Service Manual page 95

2. Service Program Mode Table
No.
All Indicators On
11*
(NOTE 2)
Misfeed Detection Off
12
Exposure Lamp Off
13*
Auto Reset On/Off
14
Auto Reset Time
15
Copy Counter Count
16
Up/Down
Auto Cassette Shift
17
ADS Priority
19
Erase Lamp Forced On
24*
(NOTE 3)
Sorter Operation
28
Toner Supply Mode
30
ID Sensor Bias (Color)
33*
(NOTE 6)
Image Bias Up
34*
ID Sensor LED On
54
Buzzer On/Off
57
Exposure Lamp Forced On
58*
(NOTE 3)
Toner Forced Supply
63*
Sorter Bin Capacity
71
Charge Corona Forced On
83*
(NOTE 3)
T/PCC Corona Forced On
84*
(NOTE 3)
Separation Corona Forced
85*
On
(NOTE 3)
QL/PTL Lamp Forced On
86*
(NOTE 3)
Mode Defaults
10: OFF
10 11: All the indicators on the Operation
Panel turn on.
10: OFF
10
11: Copies are made without misfeed detection.
10: OFF
10
11: The exposure lamp is off in Free Run mode.
10: Enables the Auto Reset.
10
11: Disables the Auto Reset.
10: 1 minute
10
11: 3 minutes
10: Up
10
11: Down
10: The copier automatically to
the other cassette for the same size/direction
11
when paper runs out.
11: OFF
10: The copier defaults to ADS when the main
11 switch is turned on.
11: Manual
10: OFF
10
11: The erase lamp is forced to turn on.
10: No sorter
10
11: The sorter is attached.
10: P-MODE (Detect Supply Mode)
10
11: C-MODE (Fixed Supply Mode)
10: Normal (590 volts)
10
11: High (620 volts)
10: Normal
10 11: The Development Bias for the
copy image is increased by +90V.
10: OFF
11: The LED of the ID sensor turns on to allow
10
Vsg to be adjusted to 4.0±0.2 V using VR101
on the main board.
10: ON
10
11: OFF
10: OFF
10 11: The exposure lamp turns on even if the copier
is not working.
10: OFF
11: The toner supply clutch turns on for 30
10
seconds if Vsp > 0.5 volts. The clutch can be
turned off by pressing the "0" key.
11: 10 Bins
12
12: 20 Bins
10: OFF
10
11: The charge corona is forced on.
10: OFF
10
11: The T/PCC corona is forced on.
10: OFF
10
11: The separation corona is forced on.
10: OFF
10
11: The QL/PTL lamp is forced on.
- 94 -
Data