Ricoh FT5034 Service Manual page 62

2. Toner Supply Clutch Replacement
1. Remove the rear cover (3 screws).
2. Lower the main board bracket (2 screws).
3. Remove the pulse generator assembly (1 screw).
4. Remove the toner supply clutch stopper (3 screws), the registration clutch
stopper (1 screw), and the development drive support bracket (3 screws, 1
E-ring, and 1 nylon clamp).
5. Remove the pulse generator disk.
6. Remove the toner supply clutch from the drive shaft.
7. Install a new toner supply clutch.
8. Reassemble the copier.
NOTE: When reinstalling the clutch stoppers, make sure that the clutch forks
are properly engaged with the stoppers.
Development Drive
Support Bracket
Toner Supply
Clutch Stopper
Registration
Clutch Stopper
Toner Supply
Clutch
Pulse Generator
Disk
Pulse Generator
Ass'y
- 61 -