Ricoh FT5034 Service Manual page 22

1) Registration Standard
The registration standard is 0 ± 2mm. If it
is 0 mm, the paper lead edge and
original lead edge is the same. But due
to lead edge erase, the copy image has
a blank margin (3.5 ± 2.5 mm).
2) Registration Adjustment
Registration can be adjusted by DGS103 on
the main board.
Original lead
edge position
Drum
6. By-pass Feed Station
The by-pass feed table does not use the same feed mechanism as the other feeding
stations. It uses a pick-up roller in addition to the feed roller and friction pad system.
To use a larger size than B4 at the by-pass feed table, the large cassette must be
installed in order to support the trailing part of the paper.
When the by-pass feed table is opened, the pick-up solenoid turns on and off once,
The by-pass feed table, add paper, and interrupt indicators turn on, and the Start key
turns red.
Paper
- 21 -
a
Original (A4)
a: lead edge erase (3.5 ± 0.5 mm)
b: registration (0 ± 2 mm)
c: lead edge blank margin
(a + b =3.5 ± 2.5 mm)
d, e: side margin (2 ± 2 mm at each side,
for full size copies. The total of both
side margins is less than 4 mm)
DGS103
CN102
Copy (A4)
d
TP103
IC107
(PSEN)
VR101
IC120
CN101
(Main Board)
b c
e
IC115