Ricoh FT5034 Service Manual page 5

1.2 INSTALLATION PROCEDURE
NOTE: 1. When lifting and moving the
copier, grasp the black painted
stays on each side as shown.
2. When the optional sorter is
installed, the above mentioned
stays can not be held. Wear
gloves to protect hands from the
edges of the copier base plate.
3. When transporting the copier,
remove all the developer and
toner inside the machine. Also
make sure to lock the scanner
with the lock plate.
1. Unpacking and Clamps Removal
1. Remove the shipping tapes from the copier
as follows:
1) From platen cover to front cover
2) Manual table
3) Feed guide (cassette insert section)
4) Transport guide plate
5) T/S corona unit
6) Toner shield glass
7) Front loading cassette lever
8) Operation panel cover
9) PTL, QL filter
10) Relay lower guide plate
2. Remove the seal from the toner tank
entrance.
3. Remove the wedge (red) from between the
registration rollers.
4. Remove the scanner lock plate cover.
5. Remove the scanner lock plate (1 screw).
(Save the scanner lock plate for future use.)
6. Reinstall the scanner lock plate cover.
7. Adjust the machine level by turning the
rubber foot on the base plate.
Scanner Lock
Plate Cover
Scanner Lock
Plate
- 4 -
Development
Lock Lever