Advertisement
Removing Paper Jams in the Finisher
If a paper jam occurs using the Finisher, a display
similar to the one on the right appears in the touch
panel display. Check where the jam occurred, and
follow the procedure below and the procedure that
appears in the touch panel display to remove the
jammed paper.
CAUTION
• When removing jammed originals or paper, take care not to cut your hands on the edges of the
original or paper.
• When removing jammed paper or when inspecting the inside of the machine, do not allow neck-
laces, bracelets or other metal objects to touch the inside of the machine, as this may result in
burns or electrical shock.
• When removing paper which has become jammed inside the machine, take care not to allow the
toner on the jammed paper to come into contact with your hands or clothing, as this will dirty your
hands or clothing. If they become dirty, wash them immediately with cold water. Washing with
warm water will set the toner and make it impossible to remove the toner stains.
• When removing paper which has become jammed inside the machine, remove the jammed paper
gently to prevent the toner on the paper from scattering and entering your eyes or mouth. If toner
enters your eyes or mouth, wash immediately with cold water and consult a physician.
1
Remove any paper protruding from the output
tray.
IMPORTANT
• When making prints with the Staple mode, do not
remove the output sheets not yet stapled. (Stapling
will be performed after removing the jammed
paper.)
2
Open the top cover and check the inside of the
Finisher.
Finisher-F1/ Saddle Finisher-F2/ Puncher Unit-B1
9-13
Advertisement
Chapters
