Advertisement
5
Set the desired binding erase width using the
[–] or [+] key, and press the [OK] key.
NOTE
• When entering values in millimeters, you can use
the Numeric keys (
control panel.
• If you enter a value outside the setting range, a
message prompting you to enter the appropriate
value will appear on the screen.
• Even when you enter the values with the Numeric
keys (
-
), you can change the values using the
0
9
[–] or [+] key.
• If you want to enter values in millimeters, press the
[mm] key.
• The default setting is 3/4" (18 mm).
6
Press the [Done] key.
The display returns to the Basic Features screen.
7
Proceed to make copies in the usual way.
NOTE
• To cancel the setting, the [Special Features], [Frame Erase], and [Cancel] keys in that order.
• You can also cancel the mode by pressing the
3-32
Erasing Shadows and Frame Lines from Copies (Frame Erase)
Clear
-
) and the
key on the
0
9
C
Reset
key. (The machine returns to the Standard mode.)
Advertisement
Chapters
