Canon ImageRunner 5000 Series User Manual page 230

5
Select the size of the original, and press the
[Next] key.
NOTE
• You can only set the Original Frame Erase mode
for original sizes shown in the touch panel display.
• To select A or B series paper size, press the
[A/B-size] key.
6
Set the desired original frame erase width
using the [–] or [+] key, and press the [OK] key.
The value set here is specified uniformly around
the original.
To set frame erase width value for the top, bottom,
left and right sides of the original independently,
press the [Adjust Each Dim.] key.
NOTE
• When entering values in millimeters, you can use
the Numeric keys (
control panel.
• If you enter a value outside the setting range, a
message prompting you to enter the appropriate
value will appear on the screen.
• Even when you enter the values with the Numeric
keys ( - ), you can change the values using the
0
9
[–] or [+] key.
• If you want to enter values in millimeters, press the
[mm] key.
• The default setting is 1/8" (4 mm).
When you select the [Adjust Each Dim.] key:
Select each side in turn and set the frame erase
width using the [–] or [+] key, and press the [OK]
key.
Clear
- ) and the key on the
0 9
C
Scanning Originals into a Box 4-33