Canon FAX-L800 User Manual page 94

2. Press the One-touch Speed Dialling button, or press CODED DIAL followed
or
0 0 0
1 2 7
4-30 Setting Up and Using Speed Dialling
by the three-digit code, where the group of telephone numbers you want to
dial is registered.
The fax starts to send the document
TEL=GROUP DIAL
01 CANON USA
TRANSMIT
SCANNING DOC.
You will see a series of brief, alternating messages that tell you the fax is
dialling, calling, then transmitting the document. The number being dialled,
name of the other party, and the transaction number of the document are also
displayed.
Here are some points you should keep in mind when you use Group Dialling:
To start scanning immediately, press START/SCAN. Otherwise the fax
will wait 5 seconds before it starts scanning. This timeout feature can be
turned off. (Q16-11)
The fax will not dial the numbers for the Group Dialling number until
you set the document on the fax. If you press the One-touch Speed
Dialling button or press CODED DIAL followed by a three-digit code,
before you load the document, the fax will prompt you:
SET DOCUMENT
If you press a One-touch Speed Dialling button, or press CODED DIAL
followed by a three-digit code, where no number has been registered, the
fax will display:
NO TEL#
12
If you want to cancel the transmission after you press a One-touch or Coded
Speed Dialling button, press STOP.
0025
P.001
Chapter 4