Canon FAX-L800 User Manual page 179

Relay Group Setup Summary (Cont'd)
5.SELECT ORIG UNIT
6.PRINT RX DOC.
7.SELECT LOCATIONS
8.TX REPORT
Chapter 9
When your fax is the relay unit, this feature forces your fax to
check the identity of the originator before it receives the document
for relay to other units.
ON
TEL =
OFF
When your fax is the relay unit, this setting determines if your fax
unit prints a copy of every document that it relays.
OFF
ON
This item allows you to select the fax units to receive the document
your unit relays. The number of fax units to receive the document
must be registered for One-touch or Coded Speed Dialling. You can
not enter a number with regular dialling.
TEL =
This feature determines if your fax unit returns a relay transmission
report to the originator after your fax unit receives and relays a
document.
TRANSMIT
NOT TRANSMIT
When your fax receives a document for relay,
it will check the identity of the originator
before it receives the document. In order for
this feature to perform correctly, the telephone
number of the orginator unit must be registered
correctly for speed dialling on your fax unit.
Press the One-touch Speed Dialling button or
press the CODED DIAL button followed by
the three-digit code where the number for the
originator fax is registered and press SET.
Your fax will receive a document for relay
without checking the identity of the
originator.
Your fax does not print a copy of every
document it relays to other fax units.
Your fax prints a copy of every document it
relays to other fax units.
Close the One-touch Speed Dialling panels
and press the speed dialling buttons where the
numbers of the fax units to receive the relay
broadcast are registered then press SET. You
can select up to 200 destinations.
After your fax unit relays a document, it sends
a transmission report back to the originator.
In order for the feature to perform correctly,
the originator's unit telephone number must be
registered on your fax for One-touch or Coded
Speed Dialling.
No relay transmission report is sent to the
originator after a document has been relayed.
Using a Relay Network 9-5