Canon FAX-L800 User Manual page 326

3.DELETE FILE
SET BOX #
PASSWORD
2.RELAY TX GROUP
1.SETUP FILE
SET RLY TX GROUP#
1.GROUP DIAL NAME
2.PASSWORD
3.SUBADDRESS
4.RX PASSWORD
5.SELECT ORIG UNIT
ON
TEL=
OFF
6.PRINT RX DOC.
ON
OFF
7.SELECT LOCATION
TEL=
8.TX REPORT
TRANSMIT
NOT TRANSMIT
9.TX START TIME
10.RELAY B'CAST
OFF
ON
2.CHANGE DATA
SET RLY GROUP TX#
PASSWORD
3.DELETE FILE
SET RLY TX GROUP#
PASSWORD
16-18 Summary of Important Settings
Delete a mailbox.
Enter the number of the mailbox you want to delete.
Enter the password protecting the mailbox you want to delete.
Set up relay box so your fax machine can relay document
transmissions to other fax machines in your area. (Q9-3)
Set up the relay box.
Set a two-digit relay group number (00-99).
Give the relay group a name (length: 24 characters).
Assign a four-digit password to protect the relay box settings.
Enter a 20-digit (max.) ITU-T subaddress.
Enter a 20-digit (max.) ITU-T password.
Set your fax to check the incoming relay command to make sure the originator
is registered.
Receives and obeys incoming relay commands for registered originators only.
Use the One-touch or Coded Speed Dialling buttons to register originators.
Receives and obeys all incoming relay commands.
Turns printing on/off for documents received for relay.
Prints a copy of every document relayed.
No copy is printed.
Use the One-touch or Coded Speed Dialling buttons to select the fax numbers
to receive the document relayed from your fax machine.
Send a TX report from your fax machine (the relay unit) to the originator of
the transmission.
Transmits a document relay report to the originator.
No report is transmitted.
Set the fax machine to hold the document from the originator and then relay it
at a specified time. Use 24-hour setting. Up to 5 time settings are possible.
Turn relay broadcasting off temporarily without cancelling or changing all of
the relay box settings.
In order for relay broadcasting to occur, this setting must be on.
Change or add the settings on the relay box.
Enter the number of the relay box you want to change.
Enter the password protecting the relay box settings.
You can now change any of the settings listed in the table above
(1. SETUP FILE).
Delete a relay box and all settings.
Enter the number of the relay box you want to delete.
Enter the password of the relay box you want to delete.
Chapter 16