Canon FAX-L800 User Manual page 91

When you register a number for One-touch Speed Dialling, Coded Speed
Dialling and Group Dialling, you can, as an option, set the time you want your
document to go out (up to 5 different times in a day). If you are using a speed
dial button that was set by someone else, and you would like your document to
go out at the preset time, verify if the preset time feature is being used for that
button. (Q4-9, 4-17, 4-24, 16-30)
Chapter 4
Here are some important points you should keep in mind when you use One-
touch Speed Dialling:
To start scanning immediately, press START/SCAN. Otherwise the fax
will wait 5 seconds before it starts scanning. This timeout feature can be
turned off. (Q16-11)
To locate and press the correct button, you may have to open the One-
touch Speed Dialling panels.
The fax will not dial the number registered for the One-touch Speed
Dialling button until you set the document on the fax for sending. If you
press the button before you load the document, the fax will prompt you:
SET DOCUMENT
If you press a One-touch Speed Dialling button where no number has
been registered, the fax tells you:
NO TEL#
12
If you want to cancel the transmission after you press a One-touch Speed
Dialling button, press STOP. (Q6-8)
When you come to a step in any procedure where you have to dial a
number, you can press a One-touch Speed Dialling button to dial.
Setting Up and Using Speed Dialling 4-27