Using the Data Port
Data Port Setup
114
WARNING: If the serial port, analog outputs, or nurse call lines
are shorted, remote communication may be lost.
Use the Data Port Setup display to set the baud rate and the protocol
of the data port on the N-600x.
The Data Port Setup display is accessed by pressing the COMM
softkey on the Setup menu.
1. With the monitor in the normal monitoring mode, press the
SETUP softkey.
2. Press the NEXT softkey twice and then press the COMM softkey.
3. Press the ADJUST UP or ADJUST DOWN buttons to select the
desired baud rate.
4. Press the SELECT softkey.
N-600x Operator's Manual