Blip Display - Nellcor OxiMax N-600X Operator's Manual

Symbols, Controls, Displays and Indicators

Blip Display

12
The pleth display includes a "wiper bar" plethysmographic
waveform, menu bar, and current measured %SpO
SatSeconds are enabled, the pleth display includes the SatSeconds
indicator and SatSeconds setting. A decimal point after the %SpO
pulse rate indicates the respective limits have been changed from the
power on defaults (Overview on page 73). Plethysmographic
waveforms with peak to peak amplitudes less than ten PAUs are
associated.
Caution: Verify the movement of the blip bar or plethys-
mographic waveform or beating heart before accepting any
displayed data as a current measurement.
When the monitor is powered by the internal battery, the pleth display
includes a horizontal battery fuel gauge positioned in the upper left
corner which shows the remaining charge (operating hours) on the
battery. If a monitor reporting low battery is connected to an AC
power source, the battery fuel gauge displays the charging progress.
The battery fuel gauge is cleared from the display once the monitor
can provide at least 15 minutes of operating time.
The blip display includes a pulse amplitude blip bar, current measured
%SpO and pulse rate, and current upper and lower %SpO
2
rate limits. If SatSeconds are enabled, the blip display includes the
SatSeconds indicator and SatSeconds setting. Decimal points after the
%SpO or pulse rate indicate that the respective limits have been
2
changed from the power-on defaults.
and pulse rate. If
2
or
2
and pulse
2
N-600x Operator's Manual