Table of Contents
Advertisement
SRC-MAX Operation with a Pulse Oximeter or Monitor
The technician must perform the test setup procedure before
performing tests 1 through 4. The following is a brief
description of each test:
Test Setup
Note:
1. Locate the Sp0
2. Connect a DOC-10 pulse oximetry cable to the pulse
12
•
Test Setup — This procedure establishes the
baseline for all the other tests. The Test Setup
procedure must be performed before performing any
or all of the SRC-MAX tests.
•
Test 1: BPM — This procedure simulates an
O
M
sensor attached to a patient indicating 60
XI
AX
BPM and 200 BPM. The test setup procedure sets up
Test 1 for 60 BPM.
•
Test 2: SpO
O
M
sensor attached to a patient ,indicating 75
XI
AX
percent blood oxygen saturation and 90 percent
blood oxygen saturation. The test setup procedure
sets up Test 2 for 75 percent blood oxygen saturation.
•
Test 3: Modulation — This procedure simulates an
O
M
sensor attached to a patient indicating low
XI
AX
and high pulse strength. The test setup procedure sets
up Test 3 for low pulse strength.
•
Test 4: Light — This procedure simulates an
O
M
sensor attached to a patient indicating low
XI
AX
and high light level passing through the patient at the
sensor site. The test setup procedure sets up Test 4
for low light level.
Refer to the applicable pulse oximeter or monitor
operator's manual for the pulse oximeter or monitor
operation and test procedures.
2
pulse oximeter or monitor.
oximeter's Sp0
2
to the monitor's Sp0
— This procedure simulates an
2
Sensor Port on the front panel of the
sensor port or the applicable OEM cable
sensor port. See Figure 7.
2
Hide quick links:
Advertisement
Table of Contents
