About The Visual Indicators - Nellcor OxiMax N-600X Operator's Manual

Symbols, Controls, Displays and Indicators

About the Visual Indicators

Table 2: Visual Indicators
Indicator
%SpO Display
2
Pulse Amplitude
Indicator (blip bar)
Plethysmographic
Waveform Display
Pulse Rate Display
AC Power
Indicator
16
Description
Shows the hemoglobin oxygen saturation level. The display value
flashes zeros during loss-of-pulse alarms and flashes the SpO
when the SpO is outside the alarm limits. During Pulse Search, the
2
monitor continues to update the display. If alarm limits have been
changed from their power-on defaults, a decimal point (.) is
displayed after the SpO
2
Indicates pulse beat and shows the relative (non-normalized) pulse
amplitude. As the detected pulse becomes stronger, more bars light
with each pulse. This indicator is available only in the blip view.
Displays a non-normalized waveform in real-time sensor signals.
The relative pulsatile strength and quality of the incoming signals
can be observed.
Displays the pulse rate in beats per minute. It flashes during
loss-of-pulse alarms and when the pulse rate is outside of the alarm
limits. During Pulse Search, the monitor continues to update the
display. Pulse rates outside of the pulse rate range of 20 to 250 bpm
are displayed as 0 and 250, respectively. If alarm limits have been
changed from their power-on defaults, a decimal point (.) is
displayed after the BPM value (112.).
Lights continuously when the N-600x is connected to an AC power
source. The indicator shows that the battery is charging. It is off
when the monitor is being powered by internal battery.
value (81.).
N-600x Operator's Manual
value
2