Table of Contents
Advertisement
O
M
Sensor Messages
XI
AX
N-600x Operator's Manual
4. Use the ADJUST UP or ADJUST DOWN buttons to select the
desired language.
5. Press the EXIT softkey.
Note: The selected language displays until the monitor is turned OFF.
The selected language can be set as a default by qualified service
personnel by following the procedures outlined in the N-600x Service
Manual.
O
M
sensor messages consist of sensor adjust condition messages
XI
AX
and sensor adjust messages which, when enabled, are displayed when
the monitor is not able to display saturation. When O
messages are displayed, it is an indication that the O
functioning properly, but the site to which the O
or the application method is not optimal for calculating %SpO
Condition messages are followed by action messages. Up to three
condition messages may be displayed on the "POOR SIGNAL
CONDITION" display in priority order, highest on top. The condition
display may be dismissed by using the EXIT softkey. Once closed,
the O
M
sensor message screen will not return until a new
XI
AX
condition occurs.
Using the Monitor
M
sensor
XI
AX
M
sensor is
XI
AX
M
sensor applies
XI
AX
.
2
69
Advertisement
Table of Contents
