Setting Up the Monitor
Connecting to an AC Power Source
24
WARNING: In the USA, do not connect the pulse oximeter to an
electrical outlet controlled by a wall switch, because the pulse
oximeter may be accidentally turned off.
Caution: The Supply Voltage Selector switch must be set to the
correct voltage (115 or 230) to avoid equipment damage and
ensure battery charging.
Caution: Use only the hospital-grade power cord provided by
Nellcor.
1. Set the Supply Voltage Selector switch to the applicable voltage.
2. Plug the female connector end of the power cord into the power
connector on the rear of the monitor.
3. Plug the male connector of the power cord into a properly
grounded AC outlet.
N-600x Operator's Manual