14 ELECTRICAL SYSTEM
14.1
14.2
100
Removing the battery
Caution
Danger of burns The voltage regulator gets very hot when the vehicle is driven.
–
Allow the voltage regulator to cool down before performing any work.
Note
Environmental hazard Batteries contain environmentally-hazardous materials.
–
Do not dispose of batteries as household waste.
–
Dispose of batteries at a collection point for used batteries.
F00138-10
Installing the battery
H00386-10
Preparatory work
–
Press and hold the kill switch
the engine stops.
–
Remove the seat. (
p. 63)
Main work
–
Hang the voltage regulator to one side.
–
Disconnect negative cable
–
Pull back positive terminal cover
tive cable from the battery.
–
3
Remove screw
.
–
4
Pull holding bracket
forward and remove battery toward
the top.
Main work
–
Insert the battery into the battery compartment with the termi-
nals facing forward and secure with holding bracket
Battery (HJTZ5S-FP-C) (
–
Mount and tighten screw
Guideline
Remaining screws,
chassis
–
3
Connect positive cable
Guideline
Screw, battery termi-
nal
–
4
Connect negative cable
Guideline
Screw, battery termi-
nal
A
Contact disks
must be mounted under screws
6
cable sockets
with the claws toward the battery termi-
nal.
–
Slide positive terminal cover
–
Position the voltage regulator.
while the engine is idling until
1
from the battery.
2
and disconnect the posi-
1
p. 131)
2
.
M6
10 Nm (7.4 lbf ft)
to the battery.
M5
2.5 Nm
(1.84 lbf ft)
to the battery.
M5
2.5 Nm
(1.84 lbf ft)
5
7
over the positive terminal.
.
and