How To Use Altimeter Mode - Seiko S833 Instructions Manual

・Current altitude is measured and displayed.
・Climbing speed is measured displayed every 10 seconds.
・The Drifit Cancel function is provided.
・Altitude calibration can be made.
・The unit of measure of altitude can be changed over between meter ("m") and feet ("ft").
※Unit of measure setting can also be made in the application. By pressing and holding Button Ⓕ to
perform Bluetooth communication, the settings made in the application take effect in the watch.
Note that those settings will not be transmitted to the watch through automatic synchronization.
・Altitude logs are recorded and stored when the Field Mode REC function is in operation.
※For details, see "Hot to Use Field Mode REC Function" on P. 142.
[CAUTION] ・If the watch temperature changes while altitude is being measured, measurement
error may result. Wear the watch on your wrist or take some other measures to
prevent the watch from being affected by temperature change.
・If the watch is placed under the running water from a faucet, very high water
pressure is applied to it. The measurement accuracy of the built-in pressure
sensor degrades temporarily, and the measurement values of altitude and
atmospheric pressure may fluctuate. If such occurred, wait for about 10 minutes
until the measurement accuracy of the sensor recovers, and then, start altitude
measurement again.
・When using the Altimeter mode in a rainy weather, wear a raincoat or the like to
prevent the watch from being exposed to splashes of rain.

How to Use Altimeter Mode

4
155