Service Mode - Roland Advanced Jet AJ-1000 Service Notes

4-2 Service Mode

[ ], [ ], [ ] + POWER ON
[ MENU ] key
SERVICE MENU PRINT MENU
PRINT MENU HEAD RANK
PRINT MENU
REPLACE HEAD
PRINT MENU
HEAD ADJUST
HEAD RANK HEAD 1
HEAD 1 21.5
HEAD RANK HEAD RANK 6
HEAD 6 21.5
REPLACE HEAD PREPARE
PREPARE 123456
NOW PROCESSING..
REPLACE HEAD FINALIZE
FINALIZE 123456
NOW PROCESSING..
HEAD ADJUST BIAS
BIAS TEST PRINT
BIAS
--- VIEW ---
HEAD ADJUST VERTICAL
VERTICAL TEST PRINT
VERTICAL
--- VIEW ---
HEAD ADJUST HORIZONTAL
HORIZONTAL TEST PRINT
HORIZONTAL
LOW
HORIZONTAL
MIDDLE
The cursor can be changed with [ ] and [ ] keys and indication can be changed with [ ] and [ ] keys.
[ _ ] is displayed when operating the setting.
The menu finishes when [ ] key is pressed when the cursor set to [H1].
[H2] is displayed when [H1] is set to the standard head.
The setting range is from -30 to +30. It can be adjusted in increments of 0.5 (displayed on [%]).
HEAD ADJUST BI-DIR.DEFAULT
BI-DIR.DEFAULT TEST PRINT
BI-DIR.DEFAULT
LOW
BI-DIR.DEFAULT
MIDDLE
The cursor can be changed with [ ] and [ ] keys and the adjustment value can be changed with [ ] and [ ] keys.
[ _ ] is displayed when operating the setting. The menu finishes when [ ] key is pressed with the cursor set to [H1].
The setting range is from 0 to 60. It can be adjusted in increments of 0.5 (displayed on [%]).
HEAD ADJUST STANDARD HEAD
STANDARD HEAD
4-2
This menu is used for entering HEAD RANK for each head.
The setting range is from 12 to 31.
> 21.5
It can be adjusted in increments of 0.1.
> 21.5
This menu is used for Head Replacement.
PREPARE should be done before replacing a head, and
FINALIZE should be done after replacing a head.
The cursor can be changed with[ ] and [ ] keys and indication
can be changed with [ ] and [ ] keys.
The menu finishes when [ ] key is pressed when the cursor set
to Head [1]. Refer to [3-1 HEAD REPLACEMENT].
PERFORMING
TEST PRINT
PERFORMING
TEST PRINT
TEST PRINT
123456
The cursor can be changed with [ ] and [ ] keys and indication can be changed
with [ ] and [ ] keys. TEST PRINT performs only with the chosen head.
When [ ] key is pressed when the cursor set to the left end, it returns to the
previous menu. The standard head is not displayed for choices.
H2 H3
2 1
H2 H3
2 1
TEST PRINT
123456
The cursor can be changed with [ ] and [ ] keys and indication can be changed
with [ ] and [ ] keys. TEST PRINT performs only with the chosen head.
The menu finishes when [ ] key is pressed when the cursor set to [H1].
H1 H2 H3
12 11 -13
H1 H2 H3
12 11 -13
This menu is displayed when Page2Bit6 (2nd digit from right)
of the System switch is set to 1.
3 > 3
This menu is used for adjusting Head Alignment.
Refer to [4-4 HEAD ALIGNMENT].
PERFORMING
TEST PRINT
H4 H5 H6
-3 2 1
H4 H5 H6
-3 2 1
PERFORMING
TEST PRINT
H4 H5 H6
5 10 -11
H4 H5 H6
5 10 -11